Please be sure to read and follow carefully all instructions thoroughly before installing or working on this underwater light. Get familiar with the correct use of this light and its safety guidelines.
For safety reasons, children under 16 or anyone who does not know these instructions or directions should not use the underwater light.
The underwater solar LED light allows you to illuminate your swimming-pool, pond or fountain without any electrical connections thanks to the built-in photovoltaic panels. It is installed directly underwater and turns on automatically at night.
It is necessary for the installation to be carried out on the wall of the pool most exposed to the sun, since the autonomy during the night will depend on it. For every hour of direct sun exposure you will have one hour of autonomy.
The light must always be submerged in water, preferably 20 or 30 cm below the pool water level.
When installing more than one light, these must be fixed on the same pool wall. Please never place them one in front of the other or at angles as they illuminate each other.
Each light can illuminate approximately a surface of 15 - 20m².
For further information: www.ledecsun.com
Remove adhesive material with the magnet before installation.
Cut off the nozzle of the polymer adhesive applicator (included).
Apply the entire content to the center of the rear panel.
Press the light firmly against the wall for a few seconds in the chosen location at about 20/30cm depth..
Model: 32008 AUTO
Assembly: one block system without air. UV filter.
Type of LED light: Osram Opto
Intensity: 320 lm
Capacity: 3200 mA
Operating voltage: 3.8 v
Type of cell: polycrystalline
Average autonomy: 7 hours (with seven hours of sun exposure)
Switching On/Off: Automatic
Operating temperature: 0º to 50º
Aprox illuminating surface: 15 - 20m²
C/ La gitanilla, 17
Málaga - España