Underwater Solar Pool Light

Illuminate your pool without installations or cables and let the sun do the rest

Buy

PATENTED DESIGN AND TECHNOLOGY

Solar Pool Lights

They are installed in minutes directly under water.
No need for construction work or electrical connections.
No drilling or draining of the pool is necessary.
Its installation is suitable for tiled, polyester, liner or reinforced sheet pools.
For chlorinated or saline water pools.

View Models

0%

Works and Connections

Our lights are installed using adhesive or magnetic attachment, without the need for drilling or draining the pool.

7h

Autonomy

The average autonomy is up to 7 hours at 320 lumens, with 7 hours of submerged sun exposure.

20m²

Of lighting

Each unit can illuminate an approximate area of 15-20 square meters.

100%

Made in Spain

With the highest quality throughout the production process.

PATENTED DESIGN AND TECHNOLOGY, SINCE 2015 ON THE MARKET.

Features of underwater solar pool lights

SOLAR ENERGY
UNDERWATER

LIGHTING
LED

WITHOUT DRILLING
OR WIRES

INSTALLATION
IN MINUTES

IT ADHERES
UNDERWATER

ON/OFF
AUTOMATIC

15 TO 20 M2
OF ILLUMINATION

1 HOUR OF AUTONOMY FOR EVERY HOUR OF SUN EXPOSURE

View Products

POOL LIGHTS WITHOUT INSTALLATION

Gallery of our solar pool lights
View Gallery

FREQUENTLY ASKED QUESTIONS

Explore the frequently asked questions below and discover more about how our solar spotlights can transform your pool experience

The installation is very simple. Just clean the surface where it will be installed, apply the flexible adhesive on the back of the spotlight, and press it firmly against the pool wall for a few seconds, directly underwater.

Yes, the adhesive included is suitable for installation directly under water.

They can be installed in all types of pools: Gresite, fiberglass, reinforced sheet, liner, masonry, pebble, etc.

Magnet models are available for liner pools. No adhesive is required for installation as they have a built-in magnetic fixing system (only suitable for liner pools with galvanized steel walls).

Yes, its correct autonomy depends on it. It is important that the installation is made on the sunniest wall of the pool. For every hour of exposure to the sun, they will have one hour of autonomy.

Yes, they can be installed in all types of pools, although for a Gresite pool you will need the adhesive fixing model.

To uninstall the bulb, rotate it firmly in one direction until the center point of the flexible adhesive peels off. Do not pry with any tool, otherwise you may damage the bulb or the pool surface.

Although the spotlights can be adhered over the holes of the old electric spotlights, it is important to take into account that the wall where they are located is sunny and that the niche is previously waterproofed. It is also important to take into account the size of the pool, each of our models has a maximum intensity of 320 lm and can illuminate a surface of between 15 and 20 m2.

Yes. Although we recommend installing them between 20 and 30 cm deep for ease of installation, they can be installed deeper if the pool requires it.

Yes, both the adhesive and the bulb are resistant to cleaning with a robot, as well as the magnetic fixing model.

The spotlight can be left installed during the winter even if the pool is covered with a winter awning. However, it is advisable to uninstall it if the pool is to be emptied or if there are heavy frosts during the winter.

To keep the spotlight out of the pool for long periods of time, remove it after the batteries have been charged for a few hours. Then replace the adhesive with the magnet that was removed during installation. The spotlight has a magnetic switch inside and this will prevent it from turning on during the months that it is not in use, keeping the battery charged for conservation.

Yes, they can be installed in both salt and chlorinated water pools for months when not in operation, keeping the battery charged for conservation.

The focus must always remain submerged. It is not advisable to expose the spotlight to the sun out of the water as it will reach high temperatures and this may reduce the life of the batteries.